Painless Performance

I am swapping in a carbed 454/th400 into a 94 silverado. My problem is that this was a theft recovery truck and they cut the wires under the brake booster and to the computer. Do you guys make a harness that I can plug into the fire wall by the brake booster to run the engine and still work all the gauges in the dash? I have been messing with it for the last 2 days and cant quite figure it out and haven't found much on the net either. It would be so much easier if I could buy a harness and have it all labeled for me. If I am not mistaken the wiper wires are in that harness too. I still have the harness for the lights but I will buy the whole thing if I have to .

part #30830 is just what you need. It will not have the wiper wires but that should be a simple task. This wire will not pug into the bulkhead connector, but you can find a pre-drilled hole on your firewall to pass the wires through. Check the homepage for a write up on this part number.