 |
 |
Painless PerformanceClassic Cars, Off-Road, 4-WheelDrive Vehicles and Race Cars |
|
  |
Page 1 of 1
|
[ 2 posts ] |
|
| Author |
Message |
|
Adamscustomshop
|
Post subject: 3-Bus Custom Fuse Panel  Posted: Wed Oct 21, 2009 2:34 pm |
|
Joined: Wed Oct 21, 2009 2:08 pm
Posts: 2
|
|
I just got done installing a Painless 12 Circuit ATO Fuse Panel part number 30001 in a 1967 Camaro with an LS1/4L60E combo in it. It worked just fine, with some additional fuses. The problem I have is that I cannot find a fuse panel with 3 different busses on it, one HOT all the time, one ACCESSORY HOT only, and one ACCESSORY/START HOT to run the computer while it is starting. It also had a lot of custom circuits installed and I didn't use a lot of the fuse panel positions as they were labeled.
If you could come up with a 3-bus fuse panel, preferably low profile and weatherproof with a cover that you can mark the circuits yourself, I think it would be a pretty good tool to have when installing wiring on custom vehicles. Kind of like your #30004 fuse panel. I have not personnaly seen one but I am guessing it is only a 2-bus. If it is a 3-bus, let me know and I'll start ordering those!
Thank you and have a good one!
Adam
|
|
  |
|
|
|
doverholser
|
Post subject: Re: 3-Bus Custom Fuse Panel Posted: Thu Oct 22, 2009 7:38 am |
|
Joined: Wed Jan 07, 2009 12:18 pm
Posts: 148
|
|
Thanks Adam for the suggestion. I'll look into it.
Dennis
|
|
| |
|
|
|
|
|
Page 1 of 1
|
[ 2 posts ] |
|
Users browsing this forum: No registered users and 1 guest |
| |
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
|
|
|
