Site Logo

Painless Performance

Classic Cars, Off-Road, 4-WheelDrive Vehicles and Race Cars
 
It is currently Thu Jul 29, 2010 6:47 am
Painless Performance: Forum
Painless Rebate Choose your rebate

All times are UTC - 6 hours [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
 Post subject: 40102- Where to tap into for switch power
PostPosted: Thu Mar 19, 2009 2:24 am 
Offline
Hang Around
Hang Around
User avatar

Joined: Thu Mar 19, 2009 2:02 am
Posts: 1
I'm currently installing the dual battery system into a 1994 Jeep YJ.
As per the instructions, I need to find a power source that is hot in the "run" and "start" positions on the ignition switch for power to the toggle switch.
The instructions also say it is important that this source not have power in the "acc" position. As far as I can tell, I only have two positions on the ignition switch aside from the first one which unlocks the steering wheel. (no accesories work in this position.) Can you offer any specific advice on which wire to tap into ?


Top
 Profile E-mail  
 
 Post subject: Re: 40102- Where to tap into for switch power
PostPosted: Fri Mar 27, 2009 9:05 am 
Offline
Painless Moderator and Terminator
Painless Moderator and Terminator
User avatar

Joined: Wed Jan 07, 2009 12:18 pm
Posts: 184
The yellow wire coming out of the ignition switch powers the coil. That would be a good wire to tap into.
Hope this helps
Dennis


Top
 Profile E-mail  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC - 6 hours [ DST ]


Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum

Search for:
Jump to:  
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
Template made by DEVPPL Flash Games